0.96" Inch OLED LCD Display 0.96" Inches DC 3-5V 4 Pin 12864 128x64 Pixel LCD Display Module IIC I2C Interface Communicate Module For Arduino Electronics Circuitry & Parts 

Description: OLED LCD Display 0.96" Inch DC 3-5V 4 Pin 12864 128x64 Pixel

These displays are small, only about 1in diameter, but very readable due to the high contrast of an OLED display. This display is made of 128×64 individual white OLED pixels, each one is turned on or off by the controller chip. Because the display makes its own light, no backlight is required. This reduces the power required to run the OLED and is why the display has such high contrast; we really like this miniature display for its crispness!

This breakout can be used with either an SPI or I2C interface – selectable by soldering two jumpers on the back. The design is completely 5V-ready, with an onboard regulator and built in boost converter. It’s easier than ever to connect directly to your 3.3V or 5V microcontroller or single board computer!

Specification:

1, high resolution: 128X64 (and 12864LCD the same resolution, but the OLED screen more pixels per unit area)

2, super wide viewing angle: more than 160 ° (maximum viewing angle display a screen)

3, ultra-low power consumption: normal display 0.06W (far below the TFT display)

4, wide supply range: DC 3V-5V (without any changes, directly compatible with common 3.3V and 5V power supply system)

5, industrial grade: Operating temperature range -30 degree ~ 70 degree

6, the ultra-small size: (length) 27.8MM * (W) 27.3MM * (thickness) 4.3MM

7, support for multiple operating modes: 3-wire SPI, 4 wire SPI, IIC

8, with chip select CS signal, you can achieve multiple SPI or IIC device on the same bus work

9, compatible with 3.3V and 5V control chip I / O level (without any set, directly compatible)

10, OLED screen, internal drive chip: SSD1306

11. Color: Any

Feature:

No need of the backlight

The display is self-illuminating

Power requirement is low

They are offering the large viewing angle

Full Compatible with Arduino

Factory configured for SPI protocol (can easily change to IIC)

Better performance characteristics than traditional LCD and LED displays.

Only Need 2 I/O Port Control

Pin definitions:

GND: power ground.VCC: 3.3V or 5V power supply.SCL: Serial Clock.SDA: Serial Data.

Applications:

MP3, MP4, watchHead-mounted displaysMeters and other intelligent instrumentsDesign any pretty patterns for your beloved electronic devices!

Package Included:

1 x OLED LCD Display 0.96" Inch DC 3-5V 4 Pin 12864 128x64 Pixel LCD Display Module IIC I2C Interface Communicate Module